FRP industry application introduction:
FRP, resin products, sandblasting machine, mold removal, wax removal, passivation effect is better than manual grinding, saving 20 times labor, and increasing efficiency 40 times!
Sand blasting of glass fiber reinforced plastic products and resin products with a sand blasting machine can quickly clean up the wax attached to the surface after demolding, passivate the surface of the product, increase roughness, make subsequent spray painting, increase the adhesion of batch powder, and life Improve 3-5 times.
After experiments, you can save 20 times the labor and increase the efficiency by 40 times.Case: A face-sized glass fiber reinforced plastic mask model, manual grinding with a hand mill takes 5-8 minutes, while using a sandblaster takes about 10 seconds, If the one-person pressure sandblasting machine produced by Meijun sandblasting equipment is used, the efficiency will be higher, which can save a lot of labor and increase the efficiency of product molding.
At the same time, the pressure-relief automatic exhaust sand blasting machine produced by Meijun is safe to use, generates air pressure when it is turned on, and removes the air pressure when it is stopped. All operations are controlled by only one person through the control switch on the hand. Welcome to understand!