Dongguan Meijun Sandblasting Equipment--Air Conditioning Sandblasting Helmet Respiratory Purification System Connection Manual
1) Connection of sandblasting helmet and thermostat :
Behind the sandblasted helmet is a 60CM tube with a standard DN20 interface at the end. The original box is equipped with a quick connector. On-site use can be selected according to the actual pipeline situation. Connector.
Then correspond to the air outlet connector on the top of the matching thermostat. Connect it with an air pipe,
2) Connection of thermostat and filter:
Air inlet for temperature control pipe (connected to compressed air) : 14MM in-line connector with copper connector (located on the side of the thermostat), this connector can be replaced as needed
The air outlet of the temperature control pipe (connected with sandblasting clothing) : It is located on the top of the main body of the temperature control pipe, and it is a standard Luo interface with an outer diameter DN25 / inner diameter DN20.
Air outlet of the filter : It is 2 in-line ball valve interfaces under the pressure gauge on the top (can be replaced with in-line connectors that match the inlet of the temperature control pipe (14mm interface is recommended)
A 14mm inner diameter trachea is selected between these two interfaces, and a throat clamp (pipe clamp) is used to lock it.
3) The filter is connected to the air compressor:
Filter air inlet: 1 inch copper ball valve located in the middle of the filter.
The connection between the filter and the air compressor is very flexible.The size of the direct plug-in interface of the filter copper ball valve is mainly selected according to the size of the air compressor interface.
| company name: Magin Dongguan Humen Meijun Wear-resistant Sandblasting Equipment Store |
| Address: No. 69, Longan 5th Road, Longyan Industrial Zone, Humen, Dongguan (No. 176 Ganglong Shop, Business Store) |
| Phone: 0769-82261696 Phone: 13215392671 http://sereio.com |
| firstname.lastname@example.org QQ: 491440166 |