Failure: a lot of abrasives enter the dust bag
Check: Check if the opening of the new adjustment bag separation adjustment belt is too large and the abrasive is too thin.
Solution: 1. Generally reduce the small mouth after 8 hours of use; 2. Use coarser abrasives.
Malfunction: Abrasive is missing at work site
Inspection: Inspect the vacuum bag for holes or unclamping.
Solution: 1. Replace the dust bag; 2. Re-clamp the dust bag.
Malfunction: Unclear vision during sandblasting
Inspection: 1. Check if the dust bag is blocked; 2. Whether the dust bag is aging or not; 3. Whether the abrasive contains too much dust; 4. Whether the recovery pipe is blocked; 5. Whether the nozzle hole is too large And whether the compressed air pressure is too high.
Solution: 1. Replace the dust bag; 2. Slap the dust bag; 3. Change the opening of the adjustment belt of the abrasive adjustment separator; 4. Check the cause of the clogging of the recovery tube; 5. The aperture cannot be larger than 5.6MM.